Hello Piro-c

Those pics are great. I love the shot of the emblem. Is there a way that one could buy that and use it here in the US? Also are those LEDs around your foglights?

Hello Black Mamba(^-^)/

First of all, both are also handmade.
Therefore, if the individual made it, it is possible to buy it by the Yahoo-auction etc. though it
doesn't exist as a commodity that the enterprise sells.
I recommend handmade because it seems that sending out to the US is
also difficult.

#####shining three diamonds
The following materials are necessary.
*Acrylic board
*LED(Ready-made goods into which resistance and the diode are built are sold in
Japan.There are a lot of people who buy LED and the diode, etc. with single goods and
make the unit by oneself, too.)
ready-made http://www.amon.co.jp/seihi/seihi_group.php?id=17
single goods http://www.korisudo.com/
*Code for wiring etc.

how to made
http://minkara.carview.co.jp/userid/273331/car/167233/285203/note.aspx
Is it a little difficult?

Installation on car
http://minkara.carview.co.jp/userid/273331/car/167233/285903/note.aspx

#####LED built-in foglight cover
The following materials are necessary.
*LED
*foglight cover
*Code for wiring etc.

how to made
http://minkara.carview.co.jp/userid/273331/car/167233/295283/note.aspx
Because you only put and fix LED to the hole of the cover, it is easier than the
emblem.

Installation on car
http://minkara.carview.co.jp/userid/273331/car/167233/297037/note.aspx
Well, if Japanese is not understood, this might be severe.

How what is it in the United States though the commodity related to LED is
abundant in Japan?

About the low:
In the law of the car of Japan, because such remodeling is a gray zone, i'm not
arrested on the road. ('-';)
I do not understand the US law of the car....
I hope the custom-made of car parts in the self-responsibility. (This phrase is often used by Japan.)

About 30 Outies participated.


Hase-pro's Outie.(custom parts shop)


member's Outie


member's Outie


member's Outie

I installed this with DIY the other day.

I ordered zontarh the Stainless Steel Sidebars at the end of last week. The arrival is the
enjoyment now.

The sidebar arrived.
It arrived in one week after it had ordered. Very promptly.
This is very an article of satisfactory.

There are some styling outlanders in japan, they're very well done. I guess it isn't illegal to add LEDs and other lighting to the outside of the cars in Japan?

Thank you for the comment.
It is not illegal for me though it is an installation such as LED outside the
car.(For the Road Traffic Law of Japan)

#LED around fog lamp
The position light until setting two(four places or less) is lawful in front
of the car.
This is considered to be one place though six LED is used for me only in one side when saying
in detail.

#emblem
On the other hand, because the emblem is not "Light of firing directly", it is
lawful.
If it is an indirect lighting, it is also possible to make it shine in the
grill. (However, red light is illegal. )

I see. Piro-c, have you modified any engine parts of your outlander? There are no engine modifications available here in north america.

Hi jkaic.
I'm sorry for the delay of the reply.

Matters of parts of engine 'relation' parts:

I have exchanged air filters.
http://minkara.carview.co.jp/userid/273331/car/167233/486063/note.aspx

As for outlander in Japan, there seem to be a lot of specifications of 2.4L-CVT, and limited parts that can be installed because of CVT.
There are a lot of light tuning such as suction, the exhausts, and the rigidity reinforcement bars.


Parts according to the category are introduced to this page.
http://minkara.carview.co.jp/parts/category.aspx?mo=5952